APC SMT 2200 VA User Manual

Installation Guide SMT 2200/3000 VA  
Input/Output Hardwire Kit  
Safety  
Adhere to all national and local electrical codes. A certified electrician must perform all electrical  
connections.  
1. Disconnect equipment connected to the UPS.  
2. Press the OFF button located on the front of the UPS.  
3. Disconnect the batteries in the UPS.  
4. Disconnect the UPS from utility power.  
NOTE: When removing the panels from the UPS, note which cable is connected to the AC input. There are two  
4-pin connectors on the UPS and they are not interchangeable.  
Inventory  
Note: The illustrations in this document may differ slightly from the actual hardware.  
Terminal block  
4 grounding screws  
8 screws  
secure input, output, and  
blank panels to the UPS  
2 wire nuts  
Terminal block label  
2 screws secure the  
terminal block to the UPS  
Input panel  
Output panel  
Blank panel  
Secure the terminal block and label to the UPS  
with two screws (supplied), as shown in the  
diagram.  
Refer to the diagram below. Use the screws supplied. Connect the ground wires with the grounding screws. Connect the  
input and output cables.  
Primary  
Ground  
Green Wire  
Input Line1  
Hot  
Ground  
Input Line2  
or Neutral  
Output Line2  
or Neutral  
Output Line1  
Hardwire Kit SMT2200/3000 VA 100/120/230 VAC Tower  
3
Connect the terminal block and UPS connectors as shown in the diagram.  
NOTE: The two pin connector will not be utilized with the replacement input and output panels.  
AC Input  
Connector  
AC Input  
Connectors  
Secure the blank panel to the UPS with three  
screws (supplied).  
APC Worldwide Customer Support  
Customer support for this or any other APC product is available at no charge in any of the following ways:  
• Visit the APC Web site to access documents in the APC Knowledge Base and to submit customer  
support requests.  
www.apc.com (Corporate Headquarters)  
Connect to localized APC Web sites for specific countries, each of which provides customer  
support information.  
Global support searching APC Knowledge Base and using e-support.  
• Contact the APC Customer Support Center by telephone or e-mail.  
• Local, country-specific centers: go to www.apc.com/support/contact for contact information.  
For information on how to obtain local customer support, contact the APC representative or other distributors from whom  
you purchased your APC product.  
4
Hardwire Kit SMT2200/3000 VA 100/120/230 VAC Tower  
Customer support and warranty information is available at the APC Web site, www.apc.com.  
© 2011 APC by Schneider Electric. APC, the APC logo, and Smart-UPS are owned by Schneider  
Electric Industries S.A.S., American Power Conversion Corporation, or their affiliated companies.  
All other trademarks are property of their respective owners.  
990-3933  
6/2011  

Morphy Richards 47060 User Manual
Marantz PMD331 User Manual
Magic Chef MCSCM12PST User Manual
LG Electronics G5300I User Manual
Kenwood KDC X715 User Manual
JVC CA MXJ10 User Manual
Denon DCD CX3 User Manual
Curtis CLXP64 User Manual
Bunn BT10 User Manual
Addonics Technologies AD44MIDE2CF User Manual